Is there an existing issue for this problem?
What part of EdgeTX is the focus of this bug?
Transmitter firmware
Current Behavior
I have been trying to have InternalGPS work and also have a model GPS position be used after received by telemetry via S-port. InternalGPS is to be connected to UART2. When this is done, all telemetry data are not fournd anymore and it is not possible to have both Model GPS position and internal transmistter position properly received and used. I presume there is a conflict in names: ahead of the 'sensor renaming' feature, both GPS signals kill each other.
FW is 2.12.1
Expected Behavior
The telemetric sensors should be found and made available even if InternalGPS has a signal. I would expect to have both signals appear and be used.
I would also expect UART1 to be used, and also other UARTs showed on the main PCB (UART3 etc)
Also, I would expect the Baud rate for the incoming GPS positions to ba also received at a higher rate than 9600. A automatic feature would adapt the TX software so it accepts a Buad rate speed up to at least 32600.
Steps To Reproduce
When no telemetry is sent / received: 'GPS' sensor shows and is available for use in widgets. All sensors are found and made available.
If a Telemetry GPS fix is received, both sensors are not displayed in the sensor list, 'GPS' stays at --, all other sensors are not found anymore. No 'internalGPS' sensor is found.
Renaming the GPS sensor does not help.
Version
2.12.1
Transmitter
RadioMaster TX16S / TX16SMK2
Operating System (OS)
No response
OS Version
No response
Anything else?
HOw come nobody can axplain what is UART1 for ? it seems to be unavailable. Please document the use and limits of all UARTso on the PCB.
Is there an existing issue for this problem?
What part of EdgeTX is the focus of this bug?
Transmitter firmware
Current Behavior
I have been trying to have InternalGPS work and also have a model GPS position be used after received by telemetry via S-port. InternalGPS is to be connected to UART2. When this is done, all telemetry data are not fournd anymore and it is not possible to have both Model GPS position and internal transmistter position properly received and used. I presume there is a conflict in names: ahead of the 'sensor renaming' feature, both GPS signals kill each other.
FW is 2.12.1
Expected Behavior
The telemetric sensors should be found and made available even if InternalGPS has a signal. I would expect to have both signals appear and be used.
I would also expect UART1 to be used, and also other UARTs showed on the main PCB (UART3 etc)
Also, I would expect the Baud rate for the incoming GPS positions to ba also received at a higher rate than 9600. A automatic feature would adapt the TX software so it accepts a Buad rate speed up to at least 32600.
Steps To Reproduce
When no telemetry is sent / received: 'GPS' sensor shows and is available for use in widgets. All sensors are found and made available.
If a Telemetry GPS fix is received, both sensors are not displayed in the sensor list, 'GPS' stays at --, all other sensors are not found anymore. No 'internalGPS' sensor is found.
Renaming the GPS sensor does not help.
Version
2.12.1
Transmitter
RadioMaster TX16S / TX16SMK2
Operating System (OS)
No response
OS Version
No response
Anything else?
HOw come nobody can axplain what is UART1 for ? it seems to be unavailable. Please document the use and limits of all UARTso on the PCB.