Noise detection stuck in Detected state

[LNich9]

Description

Hi, recently purchased a C210 to go in my daughters room and have set it through HA.

The noise detection worked well for about 6 hours and then sent through a load of false detection and then finally is now in a permanent state of Detected.

Tried HA reboot, reinstall of integration, power cycle of camera and haven't managed to make it work properly.

Reproduction Steps

1. Open Integration
2. Nav to C210 camera device
3. Open Noise binary sensor

Expected behavior

Expected: State moves between Clear and Detected as expected.

Actual: State stays stuck on Detected despite 0 noise around the camera

If applicable, add error logs.

Can't find any applicable logs but attached sensor history that shows constant activity when there is no noise present

Home Assistant 2025-10-29 21_11_54.csv

Device Firmware

1.1.3 Build 250429 Rel.60782n

Integration Version

3.0

Using stream component

Yes

Does camera work via official integrations?

Yes

Camera has all attributes filled out in developer tools

Yes

HASS Environment

RPi3 running HAOS

Search for similar issues

Yes

Additional information

No response

[DavidAtImpactCubed]

Not a fix, but note that there is a similar problem with motion detection events where they get "stuck" on, and there is a workaround here: #304 (comment)