Saving/Reloading simulation prevents it from running

[Yuri05]

• Load the project from Snapshot.zip. The only simulation runs through (which takes 13-15 minutes, but anyways).
• Save the project, close it and reopen again. Saved project.pksim5.zip
• Run the simulation - the error message below comes

The same problem occurs if after loading from snapshot the simulation is saved as pkml and loaded in PK-Sim or MoBi.

[PavelBal]

@Yuri05 I just tried and I cannot reproduce - the simulation runs after re-opening the project.

[Yuri05]

@Yuri05 I just tried and I cannot reproduce - the simulation runs after re-opening the project.

Not sure if it's good or bad news 😆