Challenge for gcode scripters

[ciprianursu1]

Hello, I have been working for the past week at a prototype infill which is supposed to mimic textiles and woven composites, but it's giving me a lot of headaches and I can't even say for sure whether it increases the strength of the part. I only tested a 100 mm long, 18mm wide and 10mm thick brick using gyroid infill and this experimental infill in a 3 point bending test without adequate measuring equipment or anything. I saw that the part was considerably more rigid and didn't bend, but just snapped whereas the gyroid one started bending at a much lower force, and didnt snap. I think that this could be a really good infill when high rigidity is needed. One downside of this is the print time which is usually double than normal, maybe just due to my poor code and logic. I have attached some images to showcase the infill's structure and I hope that some better coder than me picks up this challenge and brings it to reality while working reliably. <img