Noisemodelling v5 with DEM

[kubawyszomirski]

Hi,

After migrating to v5, I’ve been struggling to run noise_from_point_source with the terrain model enabled. Having used similar files to those from v4, the resulting contour map appears "upside down" (fig. 1). The only workaround I’ve found is manually adjusting the source‐point heights relative to the DEM elevation while keeping the receiver heights unchanged (result shown in fig. 2). However, this still feels like a hack rather than a proper solution.

[pierromond]

Hi @kubawyszomirski ,

It is very difficult to help you just with theses two images. Could you please post again your issue but following the template ?

Thank you.

Kind regards

P.S. It looks like an Issue, maybe use the issue tab !