54 lines (38 loc) · 2.02 KB

Open the Outline (table of contents) from the top right.

⚠️ Open issues

Issues affecting the latest version

Bugs

Switch randomly toggles on TLSR8253 512KB devices (#289) (HOBEIAN and Zbeacon)
Power-on behavior doesn't fully work on some devices
Press event missing on very short single presses (#438)
Telink Router sometimes unavailable? (#255)
momentary_nc not working after power loss.
(Apply the setting again)

Power draw

The cusom firmware draws more current than the original
As a result, the minimum Load increases for no-Neutral devices!
- estimated values: >4W for EndDevice, >8W for Router
- smart bulbs not recommended (<1W when brighness=0)
  ⤷ dummy load (capactior) may be required

End_device does not respond to Zigbee group commands

same issue on stock firmware (Zigbee limitation)
work-around: use Home Assistant groups or Router firmware

Failed to read state of 'Switch' after reconnect

error shows up every time the switch reboots
can safely be ignored, doesn't mean anything
discussion: #40

✅ Closed issues

Some of the already already fixed issues, only present on old fw versions.

(< 1.1.3) Telink End_device unreachable from Z2M after a while

fixed in latest build (force update if affected)
work-around: set Z2M 'Availablility check' to 10 mins or use Router firmware
discussion: #217

(= v1.1.0) Devices can't update OTA

Keep this version or flash by wire

(< v1.0.18) Custom config string bricks unit

Interacting with the device config field immediately bricks 3-4 gang devices
Recover: flash by wire

(< v1.0.17) 4-gang devices can't update OTA

Ask for support or flash by wire