Hello, I am a student and I need to install linux on a enclutra board, which is a ZX5 mounted on a ST1+ base board. I followed the "bsp usage documentation" and the "SD boot mode adjustements to Petalinux". Everything ran perfectly, so I ajusted the dip switch to their correct positions for SD boot, as specified in the documentation. But when I power up the boards, it doesn't boot or I don't see anything in serial port. Did I miss something or did something wrong ?
Hello, I am a student and I need to install linux on a enclutra board, which is a ZX5 mounted on a ST1+ base board. I followed the "bsp usage documentation" and the "SD boot mode adjustements to Petalinux". Everything ran perfectly, so I ajusted the dip switch to their correct positions for SD boot, as specified in the documentation. But when I power up the boards, it doesn't boot or I don't see anything in serial port. Did I miss something or did something wrong ?