Brief description of the changes

Type of changes

• New device
• Update existing device
• Removing a device
• General cleanup
• Other

Checklist:

• There are no passwords or secrets references in any examples.
  The only exceptions are !secret wifi_ssid and !secret wifi_password.
• The wifi or ethernet block has no static / manual ip address specified.
• The first configuration provided should be hardware definitions only.
  A more involved example can be provided in a separate configuration block.

Made for ESPHome Checklist

• Project is powered by an ESP32 or supported variant such as C3, C6, S2, S3 etc.
• Project is using ESPHome firmware
• Project name cannot contain ESPHome except in the case of ending with for ESPHome
• ESPHome configuration is open source and available for end users to modify/update
• If the device uses Wi-Fi:
  • Configuration contains esp32_improv: (documentation)
  • Configuration contains improv_serial: if there is a USB port (documentation)
• Users should be able to apply updates to your device:
  • Device can be "taken control" of by the user using the ESPHome Builder
    • Configuration includes dashboard_import: to facilitate this (documentation)
    • Configuration contains the ota.esphome component (documentation)
    • Serial flashing is not disabled
    • There are no references to secrets in the configuration
    • There are no passwords in the configuration
    • There are no static IP addresses in the configuration
    • The configuration must be valid, compile and run successfully without any user changes after taking control
    • Every entity/component (sensor, switch, etc.) must have an id defined
  • OTA Updates are provided via the update.http_request component (documentation)