Dl180 g9 - Post upgrade error

[henres]

Hello,
I would like to thank you first for your work.
I successfully upgraded, but after it, I got two errors.
270 and 329.
See the screenshot for details.

Screenshot

I'm not sure what to do. I'm new to hp proliant. Do I need the dedicated management ILO card ?

Thanks in advance for your help !

Bye

[henres]

Hello,
I tried to reinstall it, but it still not working. Do I have to let the security switch off ?
Thanks

[kendallgoto]

what's the model of your server? it looks like something is wrong with it generally unrelated to the iLO since it's complaining about the power management as well. do you have the logs from the iLO firmware install?

[henres]

Hello,
Thanks for the reply.
The model is in the title. I will do the upgrade again and share the log tonight.
But there was no error.

[kendallgoto]

thanks, I missed that. Shouldn't have any trouble here & the errors appear unrelated. Did you run the install again & can you attach the install logs?

[henres]

Hello,
Thanks for you answer, I just got back from vacations.

Trying to install 2.77 over v1.40
Here the logs:

sudo ./flash_ilo4 --direct

FLASH_iLO4 v1.18 for Linux (Mar 31 2016)
(C) Copyright 2002, 2016 Hewlett-Packard Enterprise Development Company, L.P.
Firmware image: bootloader.bin

Component XML file: CP027911.xml
CP027911.xml reports firmware version 2.50

**IMPORTANT: This operation should only be used if iLO 4 is non-responsive and
        cannot be flashed via standard methods.
        This operation will flash the firmware on the iLO 4 in this server
        with version "2.50". Following condition(s) must be met:
        1. iLO 4 Security Override Switch must be set.
Continue (y/N)? y
Trying to reset iLO 4 IOP
iLO 4 IOP IS in reset!
Flash part is 'Macronix M25L128'
Total firmware image is 0xfbc0 bytes.
**IMPORTANT: Health LED on this server may blink red during this operation.
        After flash is complete, some servers require power to be removed
        and reapplied to reset the blinking health LED.
Start programming flash part...
******** DO NOT INTERRUPT! ********
Erasing block at 0x00fe0000

Waking up iLO 4 IOP

I was thinking, maybe I have to patch on a newer version first before patching with v2.77.

[henres]

I succesfully upgrade to official v2.77 ilo.
But I can't install the custom one as the errors keep appearing at boot after installing it.

[kendallgoto]

have you turned off power and then set the Security Override Switch? it looks like the flasher is only starting and then exiting out, rather than flashing the rest of the blocks.

[henres]

What I did is :

• Shutting down
• Remove alim cable
• Security Override Switch Swap
• put back alim cable
• server up
• Boot on liveusb
• Update the firmware
• Shutdown the server
• Remove alim cable
• Security Override Switch Swap back
• put back alim cable
• server up
• Get errors