[BUG] Layer Shifts on Y Axis

[fluxdielux-a11y]

Bug

Layer Shifts on Y axis

Steps to Reproduce

Knutwurst 1.6.0
Anycubic i3 Mega Pro
TMC 2208
Older Firmware doesn’t have this bug

[stklcode]

Cannot confirm such issue on my machine. Just updated to a 1.6.0-based build and ran a quick, rather simple print (22 layers, 120x120x4.4mm) and I do not see any layer shift. Outer walls look OK and holes could be threaded easily.

Printed the same part twice without any noticeable difference.

Anycubic i3 Mega Pro with TMC 2208 drivers, firmware MEGA_P_DGUS_TMC_BLT_10.

Do you have any additional details? Did it happen once, every print or, every layer?
Probably some issue with driver current/timinigs, but I don't see any obvious changed related to this between 1.5.5 and 1.6.0