Heltec T114 Detection Sensor Configuration

[captainchaosrules]

Trying to get the Detection Sensor to work on the T114.
What should I be using for the name of the "GPIO pin to monitor"?
I have tried the GPIO # (46), The Pin # (14) and (114) with no luck so far.
Thanks

[captainchaosrules]

Based on the iOS app which has a drop down for pins 1 through 48 I also tried using Pin 6 for GPIO16. Still no luck.

[n0qbh]

This remedy also worked on my Heltec T114.
I'm using GPIO 28 on the T114.

https://github.com/orgs/meshtastic/discussions/185#discussion-7820113

[captainchaosrules]

Hi, that sounds good. For GPIO 28 are you using pin 28 in the app? So for Android you would enter 28 and then for iOS you would select 28 in the pull down menu?

[n0qbh]

Yes, I entered pin 28 and enabled weak pull up. You can check with a VOM to be sure it's working. Pullup off = 0v, on = 3.3v
In my application, with a grounded magnetic switch, it looks for a high state when the switch opens.
The private channel 0 setting does put the node out of sight to all others except the receiving node with the same settings.

[captainchaosrules]

Pin 28 is the magic pin!
It's working A-Okay now
Thanks very much for the info -