Add your KNX devices to Homey. This app requires a KNX IP Router or Interface connected to the same Wi-Fi network as Homey. Please make sure that either Homey is the only KNX/IP device in your network or that your IP interface can handle multiple simultaneous connections.
For example a wall-mounted switch that can be toggled.
For example lights that are connected to a binary outputactor. This type can only be toggled on and off.
For example a light that can be dimmed (0% - 100%). This device can only control dimmers that user percentages (KNX datapoint 5).
Button based step dimmers. For dimactors that don't or can't support direct dimming.
A light or LED Strip that can change color (Red/Green/Blue).
KNX Thermosat. Can set the setpoint temperature and get the measured temperature.
Windowcoverings like sunblinds or curtains. Currently only Up/Down is supported.
A temperature measurement device.
Alarm contact sensor.
KNX motion sensor. Can be used as binary value (true/false).
KNX smoke sensor. Return true when smoke is detected
Device within Homey which triggers a KNX scene to become active.
To set-up your KNX network in Homey, this app provides three options.
For switch devices, Homey listens for a press on a button and copies the KNX Group Address (e.g. 0/1/2).
If there is an ETS (.knxproj-file) export available, it can be uploaded to Homey to make it easier to assign KNX Group Addresses to a Homey device. Most likely your installer can provide this file for you.
It is possible to manually enter KNX Group Addresses during set-up (e.g. 0/1/2). These values can usually be found in a 'group address export' (.esf-file). Most likely your installer can provide this file for you.
KNX Networks might be complicated to set-up. Please contact your local KNX Installer if you require any assistance.